Anjielo Wifi halow Bridge Port Tool Introduction

1.1 Introduction to network port tools
For scenarios where serial ports are inconvenient to use, Anjielo provides two network port-based tools to facilitate customers to configure parameters (netat.exe) and view logs (netlog.exe). Note that both tools can only work after the bridge firmware version 12954. The following are the instructions for use.
1.1.1 Netat.exe
When you need to use AT+ commands to configure bridge parameters, you can use netat.exe.
Connect the bridge device and PC with a network cable. Double-click to run, enter the IP address of the PC, and the mac of the connected device will be displayed.
If only one device is connected, it will automatically select device 1.

If several devices are connected via a switch, you can select the device by entering a number

After selecting the device, enter the AT command to execute the AT command. The usage is consistent with the serial port.

1.1.2 Netlog.exe
When you need to use a network cable to view the debug log of the bridge, you can use netlog.exe.
Use a network cable to connect the bridge device and the PC. Double-click to run netlog.exe, enter the IP address of the PC, and the log will be automatically printed. Only the log of the device connected by the network cable will be displayed. When using it, be careful not to connect multiple devices with a switch.

 bridge network port tool nettools：Download